posted
SIGNLAB ES shortcut bridge program FOR SALE $150. Legal program, includes dongle, program cd, Signlab Manual and license disk with license codes. I don't need this. Phone is 870-862-5073 or email frisbysigns@msn.com. I would rather sell this to a fellow Letterhead than put it on Ebay
-------------------- Frisby Signs, Inc. El Dorado, Arkansas Posts: 902 | From: El Dorado, Arkansas, USA | Registered: Apr 1999
| IP: Logged |
posted
I have a Gerber 4b with an old Omnicad interface card and cable. The cables were each custom wired by the technicians @Precix that no longer keep records (so I was told) of the pin sequences used.
My situation is the Mac serial cable end pins were damaged and pulled out of sequence and I havn't had luck getting that correct sequence back.
I'm hoping someone knows something about the card I have and wheather It would work w/a PC and Signlab software like the kind you are offering.
Any feedback would be very much appreciated.
Joe @Signgraphix
-------------------- Joe McGillicuddy Signgraphix 2354 Lambert Drive, Pasadena CA jmcgillicuddy1@earthlink.net Posts: 20 | From: Pasadena, California | Registered: Oct 2003
| IP: Logged |
In short,If I could get either my existing interface working or get my hands on something like an LMK interface, the "SIGNLAB ES" offered will be something I'd like to buy from you (or get while trying to find an interface).
Again any reply will be appreciated.
-------------------- Joe McGillicuddy Signgraphix 2354 Lambert Drive, Pasadena CA jmcgillicuddy1@earthlink.net Posts: 20 | From: Pasadena, California | Registered: Oct 2003
| IP: Logged |
Printer-friendly view of this topic