posted
Here's an Edge job we just did. We didn't design the logo, just used existing logos and artwork that they use in advertising. It runs on all 4 sides. Let's see if this works.
------------------ Bruce Evans
[This message has been edited by Bruce Evans (edited March 15, 2001).]
[This message has been edited by Bruce Evans (edited March 15, 2001).]
Posts: 913 | From: Chino, CA | Registered: Nov 1998
| IP: Logged |
posted
Thanks Mark. This particular one wasn't too bad wrapping. The trouble spots on this one were the fenders. They have kind of a recesessed area. We basically carefully torch the vinyl on mold into the contour. We were able to do this one without one crease. If i had it to do over again, I'd think about using horizontal panels instead of vertical. Although using numerous horiztonals makes it easier to fix if you happen to screw up a panel.
The job had about 45 panels and took two of us a day and a half. The printing took a day and I also clear coated the prints just to be safe.
------------------ Bruce Evans
Posts: 913 | From: Chino, CA | Registered: Nov 1998
| IP: Logged |
Printer-friendly view of this topic