posted
I have 25 1 sided 14"x10" aluminumn signs to make most saying different things(danger, hard hat area ect.) so screenprinting is out of the question they will all be lettered in vinyl, no design time is required I was thinking of charging around $15-$20 each does that sound reasonable I've never made this many signs that were all different normally I would screenprint something like this if they were all the same.
posted
Hiya Rich, It sounds like you're making standard OSHA signs to me. Check with a supplier like Grimco and they'll more than likely have what you need. If you're making everything from scratch, your price sounds a little low. I would shoot for the $20-25 range. I'm figuring that it will take more than 10-15 minutes to design, then cut, weed, tape and apply graphics to a panel like this. And don't forget to add your material cost with mark up. Havin' fun, Checkers
-------------------- a.k.a. Brian Born www.CheckersCustom.com Harrisburg, Pa Work Smart, Play Hard Posts: 3775 | From: Harrisburg, Pa. U.S.A. | Registered: Nov 1998
| IP: Logged |
[ August 29, 2002, 02:28 PM: Message edited by: J & N Signs ]
-------------------- Mario G. Lafreniere (Fergie) J&N Signs Winter did show up! Posts: 1257 | From: Chapleau, Ontario | Registered: Jun 1999
| IP: Logged |
[ August 29, 2002, 01:51 PM: Message edited by: J & N Signs ]
-------------------- Mario G. Lafreniere (Fergie) J&N Signs Winter did show up! Posts: 1257 | From: Chapleau, Ontario | Registered: Jun 1999
| IP: Logged |
Printer-friendly view of this topic