posted
And happy Sunday to you all.... I am trying to do a rectangle inside a rectangle, inside another rectangle, and then on the cut vinly I will have a strip to remove to allow the color of the substrate to show through. I am trying to make the size of each cut line the same. The manual reads to go to the curve tools on the fly out window and go to the NUM key... I have no NUM key, there is a book and a question mark... and in my manual the paragraph just stops right in the middle of the sentence... the is at 14.5.1 Numerical Border Tool. Right above 14.6 the last sentence is: "Once completeted the" My VMP is 2.50. Has anyone else experienced this and have you found a solution? Thanks!
-------------------- Pat Foley Foley Signs 35812 Wells Road Coarsegold CA 93614 foleys@sierratel.com (559) 642-6264 Posts: 73 | From: Coarsegold, CA | Registered: Jan 2002
| IP: Logged |
posted
Not familiar with the vinyl pro, do you have an outline and inline feature anywhere....that's what you gotta do...
-------------------- Mario G. Lafreniere (Fergie) J&N Signs Winter did show up! Posts: 1257 | From: Chapleau, Ontario | Registered: Jun 1999
| IP: Logged |
posted
OH! That's an idea! I'll try that. I spose I could outline, and then outline again.
I wonder if there a way to measure the distance between items or even the items themselves in any of the sign software? When vectoring an image I like all my cut lines to flow and be the same size and even with that I'm thinking there's gotta be an easier way!
I'm going to go play with outlining! Thanks!
-------------------- Pat Foley Foley Signs 35812 Wells Road Coarsegold CA 93614 foleys@sierratel.com (559) 642-6264 Posts: 73 | From: Coarsegold, CA | Registered: Jan 2002
| IP: Logged |