posted
We need to cover a bunch of big windows 49"x72" with vinyl and then letter over it. Anyone is signland have a good technique for doing these without getting bubbles, creases, etc.? Thank you.
posted
I would tape the vinyl in place using the top hinge method and then put it down wet using RapidTac to ensure a wrinkle and bubble free install. Just make sure the windows are squeaky clen before you start.
------------------ Greg Gulliford aka MetroDude Metro Signs and Banners 1403 N. Greene St. #1 Spokane, WA 99202 509-536-9452
posted
CLEANING, is the biggest and most important procedure(as Greg said). Make sure you don't "contaminate the glass" with the wrong procedure !! (get it Rapid Tac clean)
Roger
------------------ Roger Bailey Rapid Tac Incorporated Waikoloa, Hawaii
posted
I taught a Jon Goodwin at the college in Brisbane. Same one by any chance? (Of course I'd know if it you were "that" Jon or not if you'd filled out a profile to display at the end of your post ) If you are the one I'm thinkin of... hows the surf?! ------------------------------------------ Never mind, I just had a look at your email address, I doubt the Jon I know is likely to be in the New England Area. (Unless its noted for killer surf) ------------------------------------------ David
------------------ David Fisher D.A. & P.M. Fisher Services Brisbane Australia da_pmf@yahoo.com
[This message has been edited by David Fisher (edited July 18, 2001).]
Posts: 1450 | From: Brisbane Queensland Australia | Registered: Nov 1998
| IP: Logged |
Printer-friendly view of this topic