posted
this is the 1st time ive set up with the truck as a vendor in a car show....lot a things i aint doin right....need some suggestions on stuff to display, and so they are portable...didnt have a lot of vinyl cut or an outside table.....but think it would be a good idea...got a roll out awning on the step van...iam gona buy some of them already air brushed car tags....thats a for sure...
------------------ joe pribish-A SIGN MINT 2811 longleaf Dr. pensacola, fl 32526 850-944-5060 BEWARE THE TRUTH.....YOU MAY NOT LIKE WHAT YOU FIND
Posts: 11582 | From: pensacola, fl. usa | Registered: Nov 1998
| IP: Logged |
posted
Hi Joe, We have been setting up at car shows and races for almost 4 years now. We are at the other end of the state from you. Our setup is a vending trailer and a 10x10 easy up tent that we hang 6 4foot by 4 foot corplast boards on, we have graphics on both sides of the corplast so we have 12 surfaces to display on, (only bad thing about corplast is it bends in the wind way too easy. we have it grommeted top and bottom, then we tie it down so it don't blow and hit someone.) We have seen other graphic vendors use A frames. and a few were they have just displayed the graphics on the walls of their trailer. Hope this helps atleast a little. Terry
------------------ Terry Scott Family Graphics Deerfield Beach, Fl
Posts: 58 | From: Deerfield Beach, Fl. USA | Registered: May 1999
| IP: Logged |
Printer-friendly view of this topic