posted
Hi heads! I was wondering if anyone would happen to have any ripped checkered flags for use as a bottom border on a racecar. Ive tried to make them but they just arren't turning out right. Ive also checked art today to find them but they did not have anything to offer.
If anyone has anything or suggestions it would be greatly appriciated.
Thank you
------------------ Ryan Ursta Ursta Graphics 27 West Shenango St. Sharpsville Pa. 16150 Call: 724•962•2206 "letters of Recommendation"
Sketch a "ripped" edge to a box shape, then scan it into your signlab, and weld the 2 together, then just use the edge you want on the side of the car. I guess if you use a rough marker you will get a rougher look if you see what I mean,
Here's an example:
Good luck!
------------------ Henry Barker #1924 akaKaftan SignCraft AB Stockholm, Sweden. A little bit of England in a corner of Stockholm www.signcraft.se info@signcraft.se
Posts: 1552 | From: Stockholm, Sweden | Registered: Nov 1998
| IP: Logged |
Printer-friendly view of this topic