posted
We are running a lot of decals on our Edge. Some of the runs are quite large (1000+) We have not been able to figure out a way to set a page break during the run so you don't end up with just one long strip of decals. We have been setting up for about 30, and then re-starting the run over and over, which is very time-consuming. Any advice??
-------------------- Imagine That Laurie Walling 734 1st Ave N. Saskatoon, SK, Canada S7K1Y1 Posts: 16 | From: Saskatoon, SK, Canada | Registered: Aug 2003
| IP: Logged |
posted
are you setting up one row of decals to fit inside the 11.8" height limitation, & then doing "repeats" of that file in GSPlot?
maybe you could do a file with 30 tightly spaced decals on it in Omega & then create the larger "page break" space just before the last row.
then you could "repeat" this file of 30 decals in GSPlot & the page break would always occur every 30 decals.
Maybe there is a way to avoid ripping the larger file that a 30-up page would need to be, but if it is not a rastor image, this method may work for you.
posted
You can set how many up you have on each pass and then set how many repeats. I haven't used an edge in a while, but check your manual under repeats?
-------------------- Terry Baird Baird Signs 3484 West Lake Rd. Canandaigua, NY 14424 Posts: 790 | From: Canandaigua, New York | Registered: Dec 2002
| IP: Logged |
Printer-friendly view of this topic