posted
When I do layouts in illustrator and import them into VMP, any circles in the layout have a small sharp corner on all four sides. Instead of being perfectly round, there is a small sharp point there. Any ideas? Also, I noticed that when importing some clipart stuff, like scrolls, etc. they are sometimes distorted a little. Any help will be followed by my utmost admiration.
-------------------- Maker of fine signs and other creative stuff. Located at 109 N. Cumberland ave. Harlan, Ky. 40831 606-837-0242 Posts: 4172 | From: Ages-Brookside, Ky. Up the Holler... | Registered: Jul 1999
| IP: Logged |
posted
Not sure if this would help, but I used to have the same problem exporting from Corel Draw. I found that if I had the layout too small in Corel and resized in Signlab, I would get jaggy edges. Now I design at actual size in Corel and I haven't had the problem since.
posted
Shaun please expain what the "reduce nodes" is for in the first place and of what benefit it is? can you set the default to leave this function off? I tried your tip..it works...I had the same thing a while back....and wondered..
posted
Yep, worked great! Now, the same thing happens when I use the shapes tool to draw out circles. Is there a setting to change the reduce nodes on that? Ive looked but didnt see anything. Thanks for the help for sure!
-------------------- Maker of fine signs and other creative stuff. Located at 109 N. Cumberland ave. Harlan, Ky. 40831 606-837-0242 Posts: 4172 | From: Ages-Brookside, Ky. Up the Holler... | Registered: Jul 1999
| IP: Logged |
![[Smile]](smile.gif)
Printer-friendly view of this topic