posted
What adhesive "cast" vinyl do you recommend for doing a wrap on vehicles, some might have curves or rivets, also to be printed with GO inks for an Encad. The last type I used was Rexam's DMCVLA3. I thought it was ok, but the only type from this distributor was the low glare cast. I didn't care to much for the low glare. Now I am out of the material and thought what you guys/gals thought. I hear the 3m, or Scotchprint makes a good printing vinyl, any suggestions?
-------------------- aka:Cisco the "Traveling Millennium Sign Artist" http://www.franciscovargas.com Fresno, CA 93703 559 252-0935 "to live life, is to love life, a sign of no life, is a sign of no love"...Cisco 12'98 Posts: 3576 | From: Fresno, Ca, the great USA | Registered: Dec 1998
| IP: Logged |
posted
Thanks Glen, I take it you have used both? Which one would you buy again?
-------------------- aka:Cisco the "Traveling Millennium Sign Artist" http://www.franciscovargas.com Fresno, CA 93703 559 252-0935 "to live life, is to love life, a sign of no life, is a sign of no love"...Cisco 12'98 Posts: 3576 | From: Fresno, Ca, the great USA | Registered: Dec 1998
| IP: Logged |
Printer-friendly view of this topic