posted
Need help. My Roland PC 60 dosn't quite cut thru the blast mask. I have the presure up all the way and the 70 blade extended quite a bit. The mask I use is Anchor hi tac.
Thanks in advance. David
-------------------- David Otero Ace Signs 5445 Edith Blvd. NE - Unit B Albuquerque, NM Posts: 70 | From: Albuquerque, NM USA | Registered: Jul 2000
| IP: Logged |
posted
If your software allows you to try setting it to 2 passes.........if not maybe you can duplicate the image and lay them exactly on top of each other so it will see two lines and cut twice.
Try it on a small piece first to test. Doing this you may allow you to back the blade pressure back down a little and readjust the blade depth so you don't cut clear through and damage the tephlon strip.
Good luck
-------------------- Ace Graphics & Printing Camdenton, MO. USA
posted
My brother uses a Roland CAMM-1 to cut sandblast mask. He had to switch to Hartco mask because it was slightly thinner and fed through the rollers better. I have tried to run mask through my PC-50 but it binds up in the print head.
I run my Anchor mask through my Gerber IV-A with Unilink board. I've been trying to kill that Gerber for 20 years and have only succeeded wounding it slightly. It is a workhorse.
-------------------- David Harding A Sign of Excellence Carrollton, TX Posts: 5089 | From: Carrollton, TX, USA | Registered: Nov 1998
| IP: Logged |
Printer-friendly view of this topic