posted
I have a graphtec 2200-30 ,I need some part to complete it ,Like the power supply ,knife holders and knifes ,also where can I find the, the software to run the plotter ,I have the drivers all ready for the machine ,any info would be help full Thank`s
-------------------- Tom Hightower Tom`s Cabinets and Fine Furnature Rancho Cucamonga ,California Posts: 3 | From: Rancho Cucamonga ,California | Registered: Dec 2002
| IP: Logged |
Tom... Please call me if you get a chance. My # is: 707 746 7172. For a free # try 1-800 854 8385...ask for tech support...talk to Eddie, Brian, or Danny. hk
-------------------- Howard Keiper Independent Contractor Benicia, Ca. thekeip@comcast.net
posted
tom ...was that you in the POLICE ACADEMY movies??????? heheheheheheheheheh
-------------------- joe pribish-A SIGN MINT 2811 longleaf Dr. pensacola, fl 32526 850-637-1519 BEWARE THE TRUTH.....YOU MAY NOT LIKE WHAT YOU FIND Posts: 11582 | From: pensacola, fl. usa | Registered: Nov 1998
| IP: Logged |
Welcome to Letterville!! This place can be a great resource as you just saw (within 15 minutes of your post you had 2 phone numbers to call with names attached). Good service, eh?
I also noticed your post on the thread about hobbies & it's good to have another cabinetmaker in Letterville (I used to have a cabinet shop in Scottsdale, AZ). By the way, are you any relation to David Hightower of Lawrence, Kansas? He turns out some mighty fine pin-stripe panels.
-------------------- Chris Elliott 1longshot@classicnet.net cell 62084two2232 Posts: 686 | From: Scottsdale, AZ & Anthony, KS, USA | Registered: Dec 1999
| IP: Logged |
posted
Well I have called them ,thank you ,I still need to talk to danny 2 graphtec ,he`s very busy ,I probably related to the other Hightower since some of my family came from Kansas ,in the 20`s ,Thank you again
-------------------- Tom Hightower Tom`s Cabinets and Fine Furnature Rancho Cucamonga ,California Posts: 3 | From: Rancho Cucamonga ,California | Registered: Dec 2002
| IP: Logged |