posted
Hi all I have a very good sign program but want to sometimes cut from corel 11 to a roland pnc1000.Thought I knew how,I don't. Any useful information welcome.(I tried the topic search no luck) Thanks Ernie
-------------------- Ernest Clark Dahlonega Sign Co. 101 Whispering Winds Dr Murrayville,Ga 30564 Been there, Done that, Probably do it again. Posts: 134 | From: Dahlonega,Ga. USA | Registered: Dec 1998
| IP: Logged |
posted
Ernest...The instructions for doing this are at... Cutting from Corel
These instructions were written a couple of years ago but they are still correct for the PNC1000 part and the instructions for Corel 8 are valid for version 11.
If you have a problem just e-mail me. I will be on holidays for the next week, but i will be checking my e-mail.
If you can wait until November25 I can walk you through the setup over the phone also. That has always been the easiest way to show someone the setup.
By the way...If you are using Windows 2000...forget about even trying this. The printer driver for 2000 will just crash your computer. Win 95/98/and XP are fine.
Hope this helps.
-------------------- Dave Grundy retired in Chelem,Yucatan,Mexico/Hensall,Ontario,Canada 1-519-262-3651 Canada 011-52-1-999-102-2923 Mexico cell 1-226-785-8957 Canada/Mexico home
posted
Thanks everyone,finally got it right.Idid know this, just a case CRS (Must be the age thing,again) Thanks Ernie
-------------------- Ernest Clark Dahlonega Sign Co. 101 Whispering Winds Dr Murrayville,Ga 30564 Been there, Done that, Probably do it again. Posts: 134 | From: Dahlonega,Ga. USA | Registered: Dec 1998
| IP: Logged |
Printer-friendly view of this topic