posted
This might help someone. I didn't like the look of this large stripe stopping at the tail light, but then I didn't want to slit the vinyl either, so I made this template first....
In this photo I taped up a piece of paper and then "eye balled" the top and bottom lines and trimed it out.
Here is the first cut to see how close it is and then I trimed as necessary to fit. Get it to fit as flat to the contour as possible.
After trimming to fit I outlined it onto another peice of paper for scanning.
Here's the result and I mirrored the other side.
I lined the edges up and hinge taped it.
Installed the left side and then the right. It worked for me! Good luck.
-------------------- Chuck Gallagher Pro Graphics Signs by Design Cabool, MO 417.962.3291 "I grew up in Letterville" Posts: 776 | From: Cabool, Mo. USA | Registered: Nov 1998
| IP: Logged |
posted
I didn't know how to get it in the Tips and Tricks section, so we'll let Barb do it.....HI BARB!!!
-------------------- Chuck Gallagher Pro Graphics Signs by Design Cabool, MO 417.962.3291 "I grew up in Letterville" Posts: 776 | From: Cabool, Mo. USA | Registered: Nov 1998
| IP: Logged |
Printer-friendly view of this topic