posted
I have a 4'x6' digital image to mount onto 1/2" thick black Ultraboard. I'm planning on using a matt laminate rather than gloss. I've experanced "outgassing" before and this is going to be mounted in a inside mall 14' up. Is there a better black foam to mount to? 1 layer is 1/2" and another smaller piece (2'x4')1" thick with prints on both layers. Siliconed together.
-------------------- John Arnott El Cajon CA 619 596-9989 signgraphics1@aol.com http://www.signgraphics1.com Posts: 1443 | From: El Cajon CA usa | Registered: Dec 1998
| IP: Logged |
posted
Hiya John, I've only used Gatorfoam for graphics that thick and never had a problem with out-gassing (or curling). I would also normally apply some iron-on edge banding. But, at 14" high, I don't think anyone would notice that it's not on there.
Havin' fun,
Checkers
-------------------- a.k.a. Brian Born www.CheckersCustom.com Harrisburg, Pa Work Smart, Play Hard Posts: 3775 | From: Harrisburg, Pa. U.S.A. | Registered: Nov 1998
| IP: Logged |
Printer-friendly view of this topic