posted
Hey folks, I'e been looking to get a relatively low cost vinyl printer (12" if we have to, would prefer a 24" to 30") to be used to produce graphics for nascar hoods, etc. While researching this, I have come to the conclusion I don't have a clue which process might be best for this. Realizing I'm cutting a few corners I probably don't need to, I was wondering if you folks had any suggestions that might speed this process along a bit. Thanks.
-------------------- Ed Harris Designs&Signs Lexington, TN
"Give me chastity and give me continence, but do not give it yet." -- Saint Augustine" Posts: 213 | From: Lexington, TN USA | Registered: Feb 1999
| IP: Logged |
posted
Sounds like you need a used Roland PC60 or 6000. The ribbons cost a little more, but the machines cost less going into it.
-------------------- John Arnott El Cajon CA 619 596-9989 signgraphics1@aol.com http://www.signgraphics1.com Posts: 1443 | From: El Cajon CA usa | Registered: Dec 1998
| IP: Logged |
posted
Interesting you should mention those two, John & Bob, I've been looking at both the PC 12 & 600. I've also noticed Ebay had some listed. That might be a way to go, though I really don't understand the processes the various machines use.
-------------------- Ed Harris Designs&Signs Lexington, TN
"Give me chastity and give me continence, but do not give it yet." -- Saint Augustine" Posts: 213 | From: Lexington, TN USA | Registered: Feb 1999
| IP: Logged |
Printer-friendly view of this topic