Anyone that knows if there is any thinner Lexan that is printable in Edge2. I need to get hold of 0,125mm.
Posted by Duncan Wilkie (Member # 132) on :
We use Lexedge by Gerber. It's punched and edge ready, don't mess around with anything else. Cheers,
Posted by Anders Elofson (Member # 3890) on :
Yes, i know, we already uses that but our customer wants a Lexan that is thinner than 0,250mm.
Posted by pierre (Member # 1462) on :
The thinnest we've used is 10 mil flexible Lexan from Sun supply in Spokane Wa. We use it for a carrier on our old 750 plotter.
k31
Posted by David Harding (Member # 108) on :
I know this is no help, but 10 mil is .25mm. If the customer needs .125 mm, they will be needing 5 mil material.
Posted by Diane Crowther (Member # 120) on :
I think Gerber must be testing a 5 mil lexan because it's showing up in the materials list of Omega 2.0. As far as I know it's not available yet.
Posted by Laura Butler (Member # 1830) on :
I was just given some .020. Its used for the little item strips for menu boards. Is this what you are talking about?
Posted by Anders Elofson (Member # 3890) on :
-Laura i think what iīm looking for is the Lexan that Diane is talking about in previous post.
I was in contact with Gerber earlier and they confirmed that they were testing a thinner (5 mil) lexan, but they couldnīt tell when it would be released. They also said that itīs a lot of people asking about thinner lexan.
![[Wink]](wink.gif)