My new 2 gig computer is screamin', but I've been doing a bit of that myself getting everything dialed in.
Now my vinyl height is defaulting to 18.75" My Graphtec plotter seems to be configured just fine & works like normal except when I put in 24" material I could always cut up to about 22.5" (depending on where the friction feed rollers were placed)
Probably an easy setting adjustment, but I am not finding where to re-set that. Hope someone has that info to help me get some promised jobs out.
[ May 14, 2002, 06:45 PM: Message edited by: Doug Allan ]
Posted by timi NC (Member # 576) on :
In the cut window there is an icon to the right of the icon with the red pencil,... you should be able to set it there,....
Posted by jimmy chatham (Member # 525) on :
DOUG when you set up the plotter you have to tell it which plotter you have. if you tell it it is a fc5120-50 it will set the default to 18.5 if you tell it it is a fc3160-60 it will set it to 22.5 hope this helps
Posted by Doug Allan (Member # 2247) on :
Thanks! Yeah Timi, I tried to set it there with no luck.
I was beginning to suspect I had selected the wrong Graphtec driver. Thanks again Jimmy, that was the trouble.
