Had to run a quick job this morning before heading out and vinyl cutter started crawling super slow?
I rebooted and it is still running slow?
Since I last used it (a few days ago) I've cleaned up the computer quite a bit, but don't believe I've deleted anything associated with this cutter?
It is cutting correctly and accuratly, just slow.
Any ideas/trobleshoot tips?
BM
Posted by brassring (Member # 1768) on :
Bernard, I have a 24" Lynx, I design in Corel and output with Signlab ES it runs slow if I try to setup more than one copy in the Signlab ES. If I need multiples I try to set them up in Corel first then output to Signlab ES then it runs fine.
Sorry if I sound too obvious but sometimes we overlook the simple things. Did you go to the plot setup and check your speed? Are you cutting from a serial port or a parallel? Are you now running windows XP? I have a 30" Lynx and in the last eight months have had both motors replaced plus two motherboards. Welcome to the world of the "cheaper" alternative.
