I just had my computer upgraded to Win 7. I got my Flexi 7.6 reloaded. I have a Roland PNC-1100 and Win 7 will not use the old driver. What do I need to set up the plotter? I appreciate all your help.
Thanks in Advance Real Mercier
Posted by Dave Grundy (Member # 103) on :
Roland quit providing drivers for the older cutters at Win XP.
There might be other "workarounds"?
If anyone knows it will either be "Old Paint/Plotter" or Curtis Hammond.
[ December 12, 2014, 07:52 PM: Message edited by: Dave Grundy ]
Posted by old paint (Member # 549) on :
go to www.rolanddg.com go to downloads, and get this file.....camm1_win7_v110.zip (9.2MB) unpack it on your computer and if you cant find a driver for the PNC-1100, try the one for a cm/cx-24. you need to know if your WIN 7 is 32 or 64 bit....there is a different d/l for 64. bit.
Posted by Dave Grundy (Member # 103) on :
My comments deleted because I humbly admit that Joe was, indeed, correct!
[ December 13, 2014, 10:43 PM: Message edited by: Dave Grundy ]
Posted by Real Mercier (Member # 362) on :
Thanks Guys. Actually Joe is correct. I did download the file for the GX-24, installed it and I am back up and running. I just did a quick run and it worked.
While I very rarely post here, I do come very often and check the board, so I knew I would get help here. I checked many other forums for an answer.
I would like to take this opportunity to say Steve and Barb are in my prayers and wish everyone here a Merry Christmas.
![[Bash]](graemlins/bash.gif)